Common Water Heater Problems

On August 16, 2016 by Himanshu

Modern Hot Water Dispensers
A water heater is one the most important everyday appliances in your home. It’s almost never turned off unless you’re away from home which is why it’s taken for granted. And, like other appliances, problems can corp up unexpectedly.

Water Leaking From the Top

The most common problem is a leaking hot water heater near the top. The leak can be due to many reasons including a lose inlet or outlet pipes for cold and hot water, failure of the T&P valve or a leaking inlet valve. The leaks are generally hard to repair and you may need hot water heating installation in Toronto to have a permanent solution.

No Hot Water

A tripped circuit breaker means you won’t get any hot water at all. In this case, you need to check the breaker box and if that’s not the problem, then the heating elements responsible for heating our water may need to be replaced.

Water Takes Too Long to Reheat

If the water heater is taking longer than usual to heat the water, there may be problems with the heating elements like sediment buildup or the thermostat not working properly. These parts may need replacement for the heater to function normally. If hot water usage in your household has significantly increased over time then you may need to invest in a new model that comes with a larger capacity tank. Plus, it’s a better option rather than replacing a few parts on an old model that may dysfunction again down the line.

Water Heater is Making Strange Noises

If your water heater makes strange hissing, popping, banging or knocking sounds, like there might be issues with the heating element like scale-buildup or the bottom of the tank might being covered with sediment.

Dirty or Rusty Colored Water

You may notice an unusual watercolor because of rust and dirt. This is due to a corroded anode or the tank itself. If left alone, the corrosion might get worse and the tank will develop a leak in future.

Smelly Hot Water

Smelly or stinky water from the water heater indicates the presence of bacteria in the tank. The problem can be temporarily treated by periodic flushing of the tank but complete cleaning is a permanent solution. Another hack for temporary cleaning is setting the water temperature up to 140 degrees which kills bacteria in the tank.

Leave a Reply

Your email address will not be published. Required fields are marked *